XD SERIES MEDIUM DUTY DUMP BODY

GENERAL

• ATSM 572 Grade 50 High Tensile steel (65ksi) inside of body
• 10GA Grade 50 front panel with integral stiffener
• Double panel side plates equal over 5/16″ thickness.
• 10 gauge outer side panels material & holding gate in down position.
• Full depth 3/16″ rear corner pillars incorporate recessed lighting, keyhole banjo eyes and lower tailgate pin receiver.
• Dirt shedding , sloped design at side plate and tailgate top
• 10″ board extension pockets
• Class 40 (single cylinder), 50 & 70 hoists available (dual cylinders)
• Epoxy primer with Phosphate prewash
• Mounting hardware and brackets provided
• All lighting is LED rubber mounted and NTEA and Federal compliant.
• DuPont™ Imron® Elite black oven cured paint w/ epoxy primer

FLOOR & UNDERSTRUCTURE

• 3/16″ Grade 50 floor w/ radius corners & single weld seam 
• 10″, 3/16″ formed long sills w/ interlaced cross members
• 4″ x 5.7# Channel cross members w/ formed  – 3/16″ cross members over hoist
• Greasable Bronze bearings for underbody release mechanisms
• Front handle tailgate release, standard
• Mounted & painted Sub frame for ease of installation
• Dual safety props

TAILGATE

• Formed 3/16″ grade 50 inner panel, 10GA outer and end panels
• 1 1/4″ lower lock pins, with forged latch receiving lock fingers.
• Adjustable 5/16” chain for spreading aggregate
• Integrated tarp hooks
• 1.50″ dia. 4140 hinge pins

CAB SHIELD

• Bolt on, multi height position, 10GA cab protector for ease of install & future optional / custom overhang.
• 24″ (1/2 cab) overhang, standard.
• Pre punched tarp mounting provisions